Siemens SIMATIC S5 ET 200U - 4.2.1 Setting the Station No. and Switch 8

4-18
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
4.2.1 Setting the Station No. and Switch 8
Use the bank of switches of the ET 200U interface module to set the station
number of your ET 200U station ( Figure 4-5). Set the station number in
binary code. Each of the first seven switches on the bank of switches has a
different positional value.
Positional value: 1
Positional value: 2
Positional value: 4
Positional value: 8
Positional value: 16
Positional value: 32
Positional value: 64
 Table 4-5
When switch is pressed (ON): the positional value is switched on
1
2
3
4
5
6
7
8
When switch is “ON”
Figure 4-5 Location of the Bank of Switches for Setting the Station Number
Setting the Station
Number
ET 200U(DP Siemens): AddressAssignment,Starting–Up,Diagnosing Faults Using COMET200