4-5
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
An ET 200U(DP Siemens) must have a station number only in the range from
3 to 124. You cannot enter the station number of an additional active station
here (if you specified one in the ET 200 SYSTEM PARAMETERS screen).
When pressing <F7> (HELP) – the cursor must be positioned in the “station
number” field – a window is displayed showing all station numbers and sta-
tion types assigned so far. You can select a station and output its configura-
tion. If station numbers have not been assigned yet, the message NO STA-
TIONS CONFIGURED is output.
4. If necessary, correct the station number that appears on the screen and
press <F6> (ENTER) to complete your entry.
Result: If the station whose number you entered has already been config-
ured, its configuration appears on the screen after you complete your entry.
If the station whose number you entered has not already been configured, two
additional entry fields appear:
ENTER HELP EXIT
F2 F3 F4 F5 F6 F7 F8F1
Station number: 3
SIMATIC S5 / COM ET 200
CONFIGURING
Area:
Station type:
Program file selected: TEST@@@@ET.200
Figure 4-2 ET 200U(DP Siemens): CONFIGURING screen (2)
“Station Number”
ET 200U(DP Siemens): AddressAssignment,Starting–Up,Diagnosing Faults Using COMET200
To Next Page
Loading...
