8-18
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
Digital Input Module (6ES5 422–8MA11)
Crimp Snap–in Connector, 40–Pin (6ES5 490–8MA12)
Screw Plug Connector, 40–Pin (6ES5 490–8MB11)
st93a001
Technical Specifications
Address identifier for ET 200U
DP Siemens
DP Standard
027
017 or 080
Number of inputs
Galvanic isolation
16
no
Input voltage L+
rated value
for “0” signal
for “1” signal
24 V DC
0 to 5 V
13 to 30 V
Input protection
against polarity reversal
against overvoltage
no, fuse trips
up to 33 V
Input current at “1” signal typ. 4.5 mA
Inherent delay
from “0” to “1”
from “1” to “0”
typ. 4 ms
typ. 3 ms
Fault LED (red) at L+/M interrupt
Connection of 2–wire BERO
proximity switches
residual current
possible
v1.5 mA
Current consumption
from +9 V (CPU)
typ. 50 mA
Length of cable
unshielded
100 m (330 ft.)
Rated isolation voltage
(+9 V to )
isolation group
12 V AC
1 B
EMC noise immunity to VDE
801–4, severity 3
2 kV
Power loss of the module typ. 4.5 W
Weight approx. 190 g
Module Spectrum
To Next Page
Loading...
