EasyManua.ls Logo

Siemens SIMATIC S5 ET 200U - Page 339

Siemens SIMATIC S5 ET 200U
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9-49
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
Input frequency and Cable Length
Symmetrical sensors (5 V si-
gnals):
S with 5 V sensor supply
max. 200 kHz for
32 m (105 ft) cable,
shielded
S with 24 V sensor supply max. 200 kHz for
100 m (328 ft) cable,
shielded
Asymmetrical sensors
(24 V signals):
max. 100 kHz for
25 m (82 ft) cable,
shielded
max. 25 kHz for
100 m (328 ft) cable,
shielded
Data transmission rate and ca-
ble length with absolute sen-
sors
62.5 kHz (selectable in
steps)
125kHz (160 m/525ft,
shielded)
250 kHz
500 kHz
1 MHz (32 m/105 ft,
shielded)
Input signals
S Incremental
S 24 V initiator (BERO)
S SSI
2 pulse trains displaced
by 90°, 1 zero pulse
1 pulse train
Absolute value
Input currents
S 5 V
S 24 V
to RS 422
typ. 5 mA
Digital Inputs
Input voltage range – 3 V to +30 V
Galvanic isolation No
0 signal – 3 V to +5 V
1 signal +13 V to +30 V
Permissible zero–signal current
at 0 signal
1.1 mA
Input current at 24 V typ. 5 mA
Other: If the digital inputs are used, they must always be
connected to a defined potential (0 V, 24 V) and must
not be kept open.
Digital Outputs
Output voltage range +20 V to + 30V
Galvanic isolation No
Output current at 1 signal max. 500 mA
Short–circuit protection Short–circuit proof
output
Cable length, screened max. 100 m (328 ft)
Supply voltage
Logic voltage from 24 V exter-
nal supply produced with swit-
ched–mode power supply
4.9 V to 5.1 V
Current consumption from
24 V without outputs and sen-
sor
typ. 120 mA
Undervoltage monitoring V
internal
< 4.65 V ³
Hardware reset
Power loss typ. 4 W
Ambient Conditions
Operating temperature 0 to 60 _C
Operating pressure 860 to 1080 hPa
Vibration load in operation 0.075 mm
at 10 to 57 Hz
1 g at 58 to 500 Hz
Electric shock in operation 15 g, 11 ms half sine
Storage temperature – 40 to +70 _C
Relative air humidity (storage) v 95 %
at T v25_C
Air pressure during storage 660 to 1080 hPa
Noise Immunity
Static noise immunity Up to 2.5 kV (except
screw terminals)
Radio–frequency interference 3 V/m
Interference on cables
S DC voltage supply cables
S Signal cables
1 kV
2 kV
Function Modules

Table of Contents

Related product manuals