Prepare and backup project
7.4 Other transfer functions
TP 270, OP 270, MP 270B (WinCC flexible)
Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0
7-23
Requirements
• The HMI device is connected to the configuration computer according to the selected
connection type.
• WinCC flexible or ProSave is installed on the configuration computer.
The ProSave Service Tool can be used to transfer authorizations. An advantage of this is
that the option can be transferred without calling in WinCC flexible.
There are two methods of transferring an option:
• Transferring an option using standalone ProSave
• Transferring an option using WinCC flexible
If an option transfer should be performed using WinCC flexible, all the general settings,
such as HMI device and transfer settings, are assumed from the project.
Procedure - transferring an option to the HMI device
Transferring an option to the HMI device
1. Start WinCC flexible via the Windows Start menu and open a project, or start ProSave via
the Windows Start menu.
2. In WinCC flexible, select the menu options "Project > Transfer > Transfer Settings" or
select the HMI device available on the "General" tab in ProSave.
3. Select the connection.
4. Enter the connection parameters.
5. Select the menu options "Project > Transfer > Options" in WinCC flexible or select the
"Options" tab in ProSave.
6. Select the options to be transferred to the HMI device from "Available options".
7. Configure the necessary transfer channel on the HMI device.
8. Switch the HMI device to transfer mode.
9. Press the ">>" button to start transferring the option.
Result
The option is transferred to the HMI device.
Procedure - transferring authorization back from the HMI device
Transferring an option back from the HMI device:
1. Start WinCC flexible via the Windows Start menu on the configuration computer and
open a project, or start ProSave via the Windows Start menu.
2. In WinCC flexible, select the menu options "Project > Transfer > Transfer Settings" or
select the HMI device available on the "General" tab in ProSave.
3. Select the connection.
4. Enter the connection parameters.
To Next Page
Loading...
Need help?
General
