Siemens SIMOCODE 3UF User Manual

Logic Modules
13.6 Flashing
SIMOCODE PRO V PN FDI
Programming and Operating Manual, 05/2020, A5E44499659002A/RS-AA/001
123
13.5.2 Non-volatile Element 1-4
Non-volatile Element 1-4
Settings:
Type
Different output responses.
Range: Level not inverted
, level inverted, edge rising with memory, edge falling
with memory
Input
Activation by any signal (any sockets e.g. device inputs, control bits from
PROFINET, etc.
Reset
Resets the Signal Conditioner to 0. Activation by any signal (any sockets e.g.
device inputs, control bits from PROFINET, etc.)
13.6 Flashing
Flashing
If an input signal is pending at its plug, the Flashing logic module issues a signal to its
socket, which alternates between binary 0 and 1 with a fixed frequency of 1 Hz. You can use
this to make the LEDs on the Operator Panel flash.
The logic module consists of:
● 1 plug
● 1 logic component
● 1 socket (Flashing Output).
Overall, there are 3 Flashing 1 to 3 logic modules.
Settings Flashing
Input
Activation by any signal (any sockets e.g. device inputs, signals,
status, etc.).

Siemens SIMOCODE 3UF Specifications

General

Brand	Siemens
Model	SIMOCODE 3UF
Category	Control Systems
Language	English