Motor Control
8.2 Control Station
SIMOCODE PRO V PN FDI
Programming and Operating Manual, 05/2020, A5E44499659002A/RS-AA/001
35
8.2.7 Releases
8.2.7.1 Releases
Releases
Releases for the control commands "ON" and "OFF", which must be activated, are assigned
to each mode of operation for every single control station. This means that depending on the
operating mode, it can be specified for each control station whether the motor may only be
switched on, off or both on and off.
8.2.7.2 Operating Mode Local 1 - S1=0 and S2=0
Operating Mode Local 1
Operating Mode Selector S1=0 and S2=0 (Operating Mode Local 1).
8.2.7.3 Operating Mode Local 2 - S1=0 and S2=1
Operating Mode Local 2
Operating Mode Selector S1=0 and S2=1 (Operating Mode Local 2).
8.2.7.4 Operating Mode Local 3 - S1=1 and S2=0
Operating Mode Local 3
Operating Mode Selector S1=1 and S2=0 (Operating Mode Local 3).
8.2.7.5 Operating Mode Remote-Auto - S1=1 and S2=1
Operating Mode Remote/Auto
Operating Mode Selector S1=1 and S2=1 (Operating Mode Remote/Auto).
To Next Page
Loading...
