Online Settings and Displays
17.2 Command
SIMOCODE PRO V PN FDI
142 Programming and Operating Manual, 05/2020, A5E44499659002A/RS-AA/001
17.1.3 Error Buffer - Error Protocol - Events DM-F
Error Buffer - Error Protocol - Events DM-F
When using a DM-F, the events "Enabling circuit closed" and "Enabling circuit open" are
logged for the "DM-F Local" and/or the "DM-F PROFIsafe" in a separate window:
● Time
● Event: "Enabling circuit closed" or "Enabling circuit open"
● Text:
– Line 1: "DM-F Local enabling circuit 0 → 1" or "DM-F PROFIsafe enabling circuit 0 → 1"
– Line 2: "DM-F Local enabling circuit 1 → 0" or "DM-F PROFIsafe enabling circuit 1 →
0".
17.2 Command
Command
In dialogue "Command" the following commands can be sent to SIMOCODE pro:
Note
Commands are immediately carried out!
Program memory module Transfer of the parameters into the memory module.
The memory module must be plugged into the system
Erase memory module Parameters in the memory module are deleted. The
memory module must be plugged into the system
Read memory module Transfer of the parameters from the memory module to
the basic unit. The memory module must be plugged
into the system interface.
To Next Page
Loading...
Need help?
General
