Siemens SIMOCODE 3UF User Manual

Logic Modules
13.8 Limit Monitor
SIMOCODE PRO V PN FDI
126 Programming and Operating Manual, 05/2020, A5E44499659002A/RS-AA/001
13.8.2 Limit Monitor 1-6
Limit Monitor 1-6
Settings:
Input Analog plug of the Limit Monitor to be connected with the analog value (2 bytes) which
is to be monitored, (e.g. maximum current I
max
, remaining cooling time, actual value of
Timers, etc.).
Type
Specifies if the limit value has to be monitored for overshooting or undershooting.
Activity Determines in which motor operating state the Limit Monitor is to be evaluated:
•
on,
i.e. always evaluate, independent of whether the motor is running or not
• on+, i.e. always evaluate, independent of whether the motor is running or not;
exception: "TPF", i.e. motor feeder is in test position.
• run, i.e. evaluate only if the motor is in the ON state and not in test position (TPF)
• run+, i.e. evaluate only if the motor is running and the start-up procedure is
finished (i.e. the "start active" message is no longer pending) and there is no Test
Position Feedback (TPF);
Example: Cos phi Monitoring.
Limit Monitor response value. The return value is always determined by the "Limit Monitor -
delay" parameter.
Range: 0 - 65535.
Delay Specifies the time period for which the limit must be constantly overshot before the
"signal - limit" output is set.
Range: 0 - 25.5 s (0.5 s)
Marking No parameters. Optional marking to designate the signal, e.g. "Limit>";
Range: Max. of 10 characters.

Siemens SIMOCODE 3UF Specifications

General

Brand	Siemens
Model	SIMOCODE 3UF
Category	Control Systems
Language	English