Device Parameters
6.2 Diagnosis
SIMOCODE PRO V PN FDI
Programming and Operating Manual, 05/2020, A5E44499659002A/RS-AA/001
21
● Cyclic update interval: Enter a value for the cyclic update interval when "Activate NTP
synchronization" check box is selected: 1... 86400 s (default value: 10 s).
● Time shift: Enter a value for the time shift: -1440 min ... +1440 min (default value: 0 min).
If you would like to set up the time in device to UTC time (recommended) please set first
+/- offset in NTP Time shift parameter in minutes respective to current time zone and then
upload the data to the device.
Start-up parameter block
With this parameter you instruct SIMOCODE pro to ignore all parameter data that are sent to
the individual devices at startup of the controller. The current parameter data that
SIMOCODE pro has saved are not overwritten by the DP master in this case. When "Startup
parameter block" is activated, you can only change the parameter data by entering new
parameters with Device Integration Manager.
Preset:
● Activated, directly in Device Integration Manager when parameterizing
● Not activated
– after factory setting
– if integrated via OM SIMOCODE.
6.2 Diagnosis
Diagnosis
It is possible to stipulate which diagnosis data can be reported via PROFINET by activating
the corresponding checkbox:
● Diagnosis for device faults
● Diagnosis for process errors
● Diagnosis for process warnings
● Diagnosis for process messages.
To Next Page
Loading...
Need help?
General
