Online Settings and Displays
17.2 Command
SIMOCODE PRO V PN FDI
144 Programming and Operating Manual, 05/2020, A5E44499659002A/RS-AA/001
Delete initialization module data With this command:
• All contents of the initialization module are deleted
• The initialization module is reset to the delivery
state.
SIMOCODE pro signals the successful deletion with
the event "Initialization module deleted".
In the event of a startup with an empty initialization
module, the basic unit signals "Trip -
Parameterization". The "General Fault" LED of the
basic unit flashes red.
Reparameterization of the device, e.g., with Device
Integration Manager, writes valid parameters to the
basic unit and the initialization module again. You can
then acknowledge the event.
Re-start: Initializing SIMOCODE pro. New run-up.
Basic factory default settings All parameters are reset to the basic factory default
settings. Only possible if no password protection exists
or the password is known to the user.
Set time (= PC time) If an NTP server address has not been configured or a
server was not found on the network, you can set the
time of day here.
If a valid time of day is available (either synchronized
by NTP or set via Device Integration Manager), the
entries in the error buffer/error protocol (i.e. log) will be
additionally displayed with the time of day. In addition,
the "Clock set (NTP)" and "Clock synchronized (NTP)"
messages are displayed.
If you would like to set up the time in device to UTC
time (recommended) please set first +/- offset in NTP
Time shift parameter in minutes respective to current
time zone and then upload the data to the device.
Test Carry out test function. Same function
as"TEST/RESET" button on the basic device and
Reset Carry out reset. Acknowledging errors.Same function
as "TEST/RESET" button on the basic device and
To Next Page
Loading...
Need help?
General
