Siemens SIMOCODE 3UF - Page 166

Online Settings and Displays
17.12 Status Information
SIMOCODE PRO V PN FDI
166 Programming and Operating Manual, 05/2020, A5E44499659002A/RS-AA/001
Indication
Meaning/Possible cause/Acknowledgement/Error processing
Initialization module identification
data write-protected
The device addressing and the I&M data in the initialization
module are write-protected. Parameterization will only be
accepted by SIMOCODE if the new parameter set is identical to
the data stored in the initialization module at that time.
• Select a parameterization with identical addressing and I&M
data
• Deactivate the partial write protection of the initialization
module.
Initialization module read in The parameters of the initialization module were read into
SIMOCODE.
Initialization module programmed The reparameterization was accepted in the initialization
module.
Initialization module deleted The initialization module was deleted and is now back in
delivery state.
Memory module read in The parameters of the memory module were read into
SIMOCODE.
Memory module deleted The memory module was deleted and is now back in delivery
state.
Memory module programmed
The reparameterization was accepted in the memory module.
Memory module write-protected The Memory module is completely write-protected.
Deactivate write protection of the initialization module.