6. Insert the connector of the ribbon cable (A) into the slot as shown below.
Note: There is no space for the ribbon cable (A) in earlier versions of the positioner. Here
you fasten the ribbon cable with the supplied cable tie at the container.
7. Secure the EMC filter module using the screw ⑥.
8. Place the basic electronics ⑤ onto the four holders of the rack.
9. Screw in the two fixing screws of the basic electronics ⑤.
10.Tighten the screws.
11.Insert the ribbon cable connector ④ of the EMC filter module onto the positioner basic
electronics.
12.Establish all electrical connections between the basic electronics and the option modules.
13.Close the positioner as described in section "Closing the standard and and intrinsically safe
version (Page 55)".
Installing/mounting
4.5 Installing the optional modules
SIPART PS2 with PROFIBUS PA
76 Operating Instructions, 05/2019, A5E00127926-AC
To Next Page
Loading...
