Siemens TC63 - Page 55

TC63 AT Command Set
2.14 AT^SCFG
s
TC63_ATC_V00.490 Page 55 of 501 5/24/05
Confidential / Draft - Do not copy
Unsolicited Result Codes
URC 1
^SCFG: "AutoExec", <AutoExecState>, <AutoExecType>, <AutoExecIndex>,
<AutoExecMode>, <AutoExecATC>
If the event specified with <AutoExecType> occurs and the related AT command line is executed this URC
is issued.
URC 2
^SYSSTART AIRPLANE MODE
This URC is issued each time the Airplane mode is activated, no matter whether Airplane mode is set with
parameter <map>="on" or <mapos>="on". The URC notifies the user that only the AT commands supported
in Airplane mode are accessible. After leaving the Airplane mode the URC "^SYSSTART" indicates that the
ME has returned to Normal mode and the full set of AT commands is accessible again.
Write Command
Configuration of URC "^SLCC" Call Status Indication
AT^SCFG="URC/CallStatus/SLCC"[, <sucs>]
Response(s)
^SCFG: "URC/CallStatus/SLCC", <sucs>
OK
ERROR
+CME ERROR
Write Command
URC indication in datamode via Ring line:
AT^SCFG="URC/Datamode/Ringline"[, <udri>]
Response(s)
^SCFG: "URC/Datamode/Ringline", <udri>
OK
ERROR
+CME ERROR
Write Command
URC indication via Ring line:
AT^SCFG="URC/Ringline"[, <uri>]
Response(s)
^SCFG: "URC/Ringline", <uri>
OK
ERROR
+CME ERROR
Write Command
Duration of active RING line for URC indications:
AT^SCFG="URC/Ringline/ActiveTime"[, <urat>]
Response(s)
^SCFG: "URC/Ringline/ActiveTime", <urat>
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last
! % % % % % % § § !