Siemens TC63 - Page 56

TC63 AT Command Set
2.14 AT^SCFG
s
TC63_ATC_V00.490 Page 56 of 501 5/24/05
Confidential / Draft - Do not copy
Parameter Description
AutoExec Command
This parameter serves to switch the Autoexec function on or off.
If it is switched off (<AutoExecCmd>=0), parameters following <AutoExecIndex> are ignored and all settings
at the given index are restored to their default values.
Value will be saved while switching off the TC63 via AT commands (e.g. AT+CFUN or AT^SMSO) and restored
on next power up.
“0“ Disable automatic execution of the AT command(s) specified with <AutoEx-
ecATC> at a given <AutoExecIndex>.
“1“ Enable automatic execution of the AT command(s) specified with <AutoExe-
cATC> at a given <AutoExecIndex>. Not allowed for <AutoExecType>=0
(DTR line activation) while multiplex mode is active, refer to AT+CMUX.
AutoExec Event Type
This parameter selects the kind of event used to automatically launch the AT command(s) specified with
<AutoExecATC>.
Value will be saved while switching off the TC63 via AT commands (e.g. AT+CFUN or AT^SMSO) and restored
on next power up.
“0“ Autoexec activity is driven by ASC0 DTR line activation (OFF-ON transition).
“1“ Autoexec activity is timer driven. To specify the time span use <AutoExecPe-
riod>.
AutoExec Command Index
This parameter specifies the command storage index. The following table shows the index ranges supported for
each variant of <AutoExecType>.
Value will be saved while switching off the TC63 via AT commands (e.g. AT+CFUN or AT^SMSO) and restored
on next power up.
AutoExec Command Mode
0...255
This parameter specifies details regarding the behavior of the TC63 when the AT command starts to be exe-
cuted.
Value is interpreted as a bit field, unused bits are reserved for future use (RFU) and shall be set to 0.
When a call is released by an Autoexec activity, no release indication may be issued on the first logical channel.
If during a data call the TC63 temporarily enters command mode via +++ no AT command will be executed if
<AutoExecMode> specifies 'Ignore ongoing calls'.
Value will be saved while switching off the TC63 via AT commands (e.g. AT+CFUN or AT^SMSO) and restored
on next power up.
<AutoExecCmd>
(str)(+CSCS)
<AutoExecType>
(str)(+CSCS)
<AutoExecIndex>
(str)(+CSCS)
<AutoExecType> value <AutoExecType> event Valid Indices
0 Autoexec activity is driven by ASC0 DTR
line activation
0
1 Autoexec activity is timer driven. 0-2
<AutoExecMode>
(str)(+CSCS)