10
ENEN
o Wear personal protective equipment.
o Observe the relevant safety data sheets
when handling lubricants/equipment.
1.3 Qualified technical personnel
Only qualified technical personnel may
install, operate, maintain, and repair the
products described here.
Such persons are familiar with the relevant
standards, rules, accident prevention regu-
lations, and assembly conditions as a result
of their training, experience, and instruction.
They are qualified to carry out the required
activities and in doing so recognize and
avoid any potential hazards. The definition of
qualified personnel and the prohibition against
employing non-qualified personnel are laid
down in DIN VDE 0105 and IEC 364.
Relevant country-specific definitions of qua-
lified technical personnel apply for countries
outside the scope of DIN VDE 0105 or
IEC 364.
The operator is responsible for assigning
tasks and the area of responsibility.
The personnel must be trained and instructed
prior to beginning work if they do not possess
the requisite knowledge.
Product training can also be performed by
SKF in exchange for costs incurred.
1. Safety instructions
To Next Page
Loading...
Need help?
General
