15
1
ENEN
1. Safety instructions
1.13 Residual risks
Residual risk Remedy
Life cycle: Assembly
Electric shock due to defective power
lead/mains plug
• Inspect the power lead/mains plug for damage before starting the product
People slipping due to floor contaminati-
on with spilled/leaked lubricant
• Exercise caution when connecting the product’s hydraulic connections
• Promptly apply suitable binding agents and remove the leaked/spilled lubricant
• Follow operational instructions for handling lubricants and contaminated parts
Tearing/damage to lines when installed
on moving machine components
• If possible, do not install on moving parts; if this cannot be avoided, use flexible hose lines
Life cycle: Commissioning / operation
Electric shock due to defective power
lead/mains plug
• Inspect the power lead/mains plug for damage before starting the product
Lubricating oil spraying out due to faulty
component fitting / faulty line connection
• Securely tighten all components with a suitable tool or using the specified torques. Use
hydraulic screw unions and lines suitable for the indicated pressures. These must be checked
for proper connection and for damage prior to commissioning
Life cycle: Setup, retrofit
People slipping due to floor contaminati-
on with spilled/leaked lubricant
• Exercise caution when undoing or connecting the product’s hydraulic connections
• Promptly apply suitable binding agents and remove the leaked/spilled lubricant
• Follow operational instructions for handling lubricants and contaminated parts
To Next Page
Loading...
Need help?
General
