SKF MKU Series User Manual

9
1
ENEN
1. Safety instructions
1.1 General safety instructions
The operator must ensure that the assembly
instructions/operating instructions are read
by all persons tasked with working on the
product or who supervise or instruct such
persons. The operator must also ensure that
the staff fully understands the content of the
instructions.
The assembly instructions/operating in-
structions must be kept readily available
together with the product.
Note that the assembly instructions/operating
instructions form part of the product and
must accompany the product if sold to a
new owner.
The product described here was manu-
factured according to the state of the art.
Risks may, however, arise from its usage
and may result in personal injury or damage
to material assets.
Any malfunctions which may affect safety
must be remedied immediately. In addition
to the assembly instructions/operating in-
structions, statutory regulations and other
regulations for accident prevention and
environmental protection must be observed
and applied.
1.2 General behavior when handling the
product
o The product may only be used in aware-
ness of the potential dangers, in proper
technical condition, and according to the
information in this manual.
o Personnel must familiarize themselves
with the function and operation of the
product. The specified assembly and ope-
rating steps and their sequences must be
observed.
o Any unclear points regarding proper con-
dition or correct assembly/operation must
be clarified. Operation is prohibited until
issues have been clarified.
o Unauthorized persons must be kept away
from the product.
o All safety instructions and in-house inst-
ructions relevant to the particular activity
must be observed.
o Responsibilities for different activities
must be clearly defined and observed.
Uncertainty seriously endangers safety.
o Protective and safety mechanisms must
not be removed, modified, or disabled
during operation and must be checked
for proper function and completeness at
regular intervals.
If protective and safety mechanisms
must be removed, they must be installed
immediately following conclusion of work
and checked for proper function.
o Any malfunctions that occur must be
resolved according to responsibility. The
supervisor must be notified immediately
in case of malfunctions outside one's indi-
vidual scope of responsibility.
1. Safety instructions

SKF MKU Series Specifications

General

Brand	SKF
Model	MKU Series
Category	Water Pump
Language	English