109
Scope Multimeter Operations
Data
The Data icon on the toolbar switches the trace details information at the base of the screen as
previously in Trace Details on page 94.
Cursor Controls
The cursor controls include a Show Cursors check box plus a slide control and arrows for moving
the cursor position left or right. Select Cursors from the toolbar to open the Cursors dialog box
(Figure 8-27).
1— Cursor 1 controls
2— Cursor 2 controls
3— Show or Hide icon
4— Back icon
Figure 8-27 Cursor controls
Cursor 1, the top slider and arrows, is the left-hand cursor on the screen. Cursor 2, the lower set
of controls, is the right-hand cursor on the screen. Drag the slider or select the arrows to position
the cursors. Each tap of the stylus moves the cursor incrementally in the direction of the arrow.
• Select Show to display the cursors (the icon changes to Hide).
• Select Hide to conceal the cursors (the icon changes to Show).
• Select Back to close the dialog box.
Refresh Controls
Selecting the Refresh icon from the Scope Multimeter Toolbar clears the minimum and maximum
digital values and updates the viewing screen.
To Next Page
Loading...
Need help?
General
