27
Scanner Operations Basic Operation and Navigation
Graph View
Graph View allows you to simultaneously display up to 16 parameter graphs (Figure 4-6). The
graphs must first be opened in the data list in order to be included when Graph View is selected
from the toolbar. The display defaults to a single graph if more than 16 graphs are open when the
toolbar icon is selected. Should this happen, return to the data list and close some of the graphs.
A toolbar in Graph View allows you switch scale and sweep values on and off, and to return to the
List View. The Data Buffer toolbar at the base of the screen remains active.
i The screen does not scroll in Graph View mode, it adjusts to show only the selected parameters.
Figure 4-6 Sample Graph View screen
Graph View mode can also be engaged from the custom data list configuration screen. Refer to
Custom on page 24 for details.
z To use Graph View:
1. Open the graph for each data parameter, up to sixteen, that you wish to view.
2. Configure parameter settings, such as Triggers, Auto Scale, and Sweep, as needed.
Remember, these must be selected before entering Graph View.
3. Select Graph View on the Scanner toolbar.
All of the open data graphs now appear on a single screen (Figure 4-6).
4. Select List View on the Scanner toolbar to return to a normal view.
To Next Page
Loading...
Need help?
General
