I2773-4.4 en
103
Somat eDAQ
lite
Necessary Equipment
The TCE software supports the following network camera devices:
NOTE
HBM only supports the devices listed in the above table and assumes no risk if any
other devices are used.
To use an Axis network camera to record and view video, the following equipment is
required:
•
a networked eDAQ or eDAQ
lite
with compatible firmware
•
a power over ethernet (POE) switch (HBM recommends the Korenix JetNet)
•
a support PC with a JavaScript-enabled web browser
•
a TCP/IP network (DHCP recommended)
Setting the Camera to Factory Defaults
To configure a new camera or reconfigure an existing camera, first set it to factory
defaults.
To reset the camera to factory defaults:
1. Remove power from the camera.
2. Press and hold the control button and reapply power to the camera from the
POE
port on the switch.
3. After the status indicator turns amber, release the control button.
4. Wait for the status indicator to turn green, which indicates that the camera has been
reset. This may take up to two minutes.
NOTE
The location of the control button and status indicator depends on the camera model.
For information on specific models, refer to the Axis documentation.
Configuring a Camera
To configure a network camera device:
1. If not already, power on the camera and connect it to the network via a shielded
Ethernet cable to the POE switch.
2. Open a JavaScript-enabled web browser and enter the IP addr
ess of the
networked eDAQ
lite
to display the eDAQ
lite
web interface.
Device Compatible TCE Version
Axis 211 Network Camera TCE 3.14 or later
Axis M7001 Video Encoder TCE 3.15 or later
Axis P1311 Network Camera TCE 3.15 or later
Axis P1344 HD Network Camera TCE 3.15 or later
Korenix JetNet POE Switch TCE 3.15 or later
HBM: public
To Next Page
Loading...