About i.LINK
The DV jack on this unit is an i.LINK-compliant DV input/output jack. This section
describes the i.LINK standard and its l_atures.
What is" i.LINK" ?
i.LINK is a digital serial interface fur handling digital video, digital audio and other
data in two directions between equipment having the i.LINK jack, and for controlling
other equipment.
i.LINK-compatible equipment can be connected by a single i.LINK cable. Possible
applications are operations and data transactions with various digital AV equipment.
When two or more i.LINK-compatible equipment are connected to this unit in a daisy
chain, operations and data transactions are possible with not only the equipment that
this unit is connected to but also with other dovices via the directly connected
equipment.
Note, however, that the method of operation sometimes varies according to the
characteristics and specifications of the equipment to be connected, and that operations
and data transactions are sometimes not possible on some connected equipment.
Note
Normally, only one piece of equipment can be connected to this unit by the i.LINK
cable (DV cable). When connecting this unit to i.LINK-compatible equipment having
two or more i.LINK jacks (DV jacks), refer to the operating instructions of the
equipment to be connected.
Q*
O
i.LINK is a more familiar tern] for IEEE 1394 data transport bus proposed by SONY,
and is a trademark approved by many corporations.
IEEE 1394 is an international standard standardized by the Institute of Electrical and
Electronic Engineers. 3,
i.LINK's maximum baud rate varies according to the equipment. Three maximum baud
rates are defined:
SI00 (approx. 100 Mbps*)
$200 (approx. 200 Mbps)
$400 (approx. 400 Mbps)
The baud rate is listed under" Specifications" in the operating instructions of each
equipment. It is also indicated near the i.LINK jack on some equipment.
The maximum baud rate of equipment on which it is not indicated such as this unit is
"SIOO".
When units are unit is connected to equipment having a different maximum baud rate
the baud rate sometimes differs from the indicated baud rate.
*What is" Mbps" ?
Mbps stands for megabits per second, or the amount of data that can be sent or received
in one second. For example, a baud rate of 100Mbps means that 100megabits of data
can be sent in one second.
191
To Next Page
Loading...
