- Playback- Basics-
Playing back a tape
You can monitor the playback picture on the LCD screen. If you close the LCD panel,
you can monitor the playback picture in the viewfinder.
You can control playback using the Remote Commander supplied with your
camcorder.
(1) Install tile power source and insert the recorded tape.
(2) Set the POWER switch to VCR while pressing the small green button.
(3) Open the LCD panel while pressing OPEN.
(4) Press _ to rewind the tape.
(5) Press _ to start playback.
(6) To adjust tile volume, press either of the two buttons on VOLUME. When you
close the LCD panel, sound is muted.
PLAY
To stop playback
Press B.
When monitoring on the LeD screen
You can turn the LCD panel over and move it back to the camcorder body with the LCD
screen facing out.
,÷
34
To Next Page
Loading...
