Dubbing only desired scenes - Digital program editing (on tapes)
You can connect both an A/V connecting cable and an i.LINK cable (DV connecting
cable).
When you use the A/V connecting cable, connect tile devices as illustrated in page 71.
When you use an i.LINK cable (DV connecting cable), connect the devices as illustrated
on page 72.
If you connect using an LLINK cable (DV connecting cable)
With a digital4o-digital connection, video and audio signals are transmitted in digital
format for high quality editing.
iii !i ili!
To edit using the VCR, send the control signal by infrared rays to the remote sensor on
the VCR. -_
When you connect using an A/V connecting cable, follow the procedure below, steps _=
(1) to (4), to send the control signal correctly.
(1) Set the IR SETUP code
@ Set tile POWER switch to VCR on your camcorder.
@ Turn the power of the connected VCR on, then set tile input selector to LINE.
When you connect a video camera recorder, set its power switch to VCR/VTR.
@ Press MENU to display the menu settings.
@ Turn the SEL/PUSH EXEC dial to select _, then press the dial.
@ For DCR-TRV240:
Turn the SEL/PUSH EXEC dial to select VIDEO EDIT, then press tile dial.
For DCR-TRV340/TRV740/TRV840:
Turn the SEL/PUSH EXEC dial to select TAPE in VIDEO EDIT, then press the
dial.
@ Turn the SEL/PUSH EXEC dial to select EDIT SET, then press the dial.
(Z) Turn the SEL/PUSH EXEC dial to select CONTROL, then press the dial.
(_) Turn the SEL/PUSH EXEC dial to select IR, then press tile dial.
_) Turn the SEL/PUSH EXEC dial to select IR SETUP.
Turn the SEL/PUSH EXEC dial to select IR SETUP code number of your VCR,
then press the dial.
Check tile code in "About IR SETUP codes." (p. 77)
75
To Next Page
Loading...
