Dubbing only desired scenes - Digital program editing (on tapes)
Make sure that your camcorder and VCR are connected, and that the VCR is set to
recording pause. When you use an i.LINK cable (DV connecting cable), the following
procedure is not necessary.
When you use a digital video camera recorder, set its power switch to VCR/VTR.
(1) For DCR-TRV240:
Turn the SEL/PUSH EXEC dial to select VIDEO EDIT, then press tile dial.
For DCR-TRV340/TRV740/TRV840:
Select VIDEO EDIT in the menu settings. Turn tile SEL/PUSH EXEC dial to
select TAPE, then press the dial.
(2) Select START in the menu settings. Turn tile SEE/PUSH EXEC dial to select
EXECUTE, then press tile dial.
Search for the beginning of the first program, then start dubbing.
The program mark flashes.
The SEARCH indicator appears during search, and tile EDITING indicator
appears during edit on the screen.
The program mark changes to light blue after dubbing ends.
When dubbing ends, your camcorder and the VCR automatically stop.
To stop dubbing during editing
Press • on your camcorder.
To end the Digital program editing function
Your camcorder stops when thedubbing ends.Then the display returns to VIDEO
EDIT in the menu setlings.
Press MENU to end the Digital program editing function.
You cannot record on the VCR when:
The cassette has run out of tape.
The write-protect tab on the cassette is set to lock.
The IR SETUP code is not correct (when IR is selected).
The button to cancel recording pause is not correct (when IR is selected).
NOT READYappears on the LCDscreen when:
The program to operate Digital program editing has not been made.
i.LINK is selected but an i.LINK cable (DV connecting cable) is not connected.
The power of the connected VCR is not turned on (when you set i.LINK).
g
87
To Next Page
Loading...
