11.4 11.4: SOLO > FOLLOW OUTPUT SOLO
11.4: SOLO > FOLLOW OUTPUT SOLO
11.4: Follow Output Solo Mode
The Follow Output Solo [FLW] keys allow the user to quickly identify and adjust those input channels that are making
contributions to each of the 24 outputs.
There are three [FLW] keys: there is one fader key and two Vistonics area keys. Only one key can be active at any
one time.
The behaviours of the Follow Output Solo mode are as follows:
* If Follow Solo is NOT active for faders or Vistonics™ encoders, pressing a Group or Aux Output Solo will activate
an Output Solo, and it will also display the EQ/Dyn/Misc touch screen area for the Soloed Output on the Master Bay
Vistonics screen (in the space normally occupied by the Input Meter display) - unless the ‘Lock Meters’ [LOCK MTR]
button adjacent to the Vistonics display is active.
* If Follow Solo is ACTIVE for either faders or Vistonics encoders, pressing a Group or Aux Output [SOLO/SEL] will
work as described above, and will also switch the input channel faders or encoders to be assigned to the Soloed bus-
ses’ contributing sends.
* If a Matrix Output [SOLO/SEL] is pressed, regardless of the setting of Follow Solo modes, the Output Solo will be
activated, the EQ/Dyn/Misc touch screen for the Matrix Output displayed, and the channel faders will be assigned to
the contribution levels from the Outputs to the Soloed Matrix Output.
Note: the lower [FLW] key has an additional function in allowing VCAs to control the Aux sends of input chan-
nels. See Mute & VCA Groups reference chapter 9 for details.
To Next Page
Loading...
Need help?
General