Vi3000 USER MANUAL
6.4: INPUT CHANNEL > VST CONTROL
Input VISTONICS Buttons (VST Section Control)
Pre/Post Field / Group: Active
Congure Aux sends
from channels (when
they are assigned to the
two VST encoder rows),
as pre or post-fader.
VST Mode: Pan Field / Group: Active
Activate aux paning
for encoders where
applicable.
If a stereo Aux is assigned to a VST encoder row, and
if the [PAN] key is active, the encoder will control the
Aux Pan rather than the contribution level. If both Auxes
assigned to Row 1 & 2 are Stereo Auxes, both Rows 1
and 2 will change to the PAN function across the desk. If
only one of the two rows is a Stereo Aux, then only this
row will change to PAN. If neither row has a Stereo Aux
assigned, the [PAN] switch will have no function.
Activate
Mode
Fast Assign Field / Group: Active
Provides a very fast way
to temporarily assign a
bus function to a VST
encoder row.
Press and hold one of the [FAST ASSN] keys, then press
one of the Output Masters’ [SOLO/SEL] keys.The rele-
vant row of VST encoders will now be assigned to that
Output master, and the [FAST ASSN] key in question
will illuminate. There will be no inuence on audio, the
Output solo is not activated.
Activate
Mode
These buttons control the functionality of the input channel VST encoders.
You can easiliy and rapidly assign bus contributions and bus panning to the encoders using this button group.
To Next Page
Loading...
Need help?
General