18.1.1 18.1.1: VM ² > DEVICE LIST
18.1.1: VM ² > DEVICE LIST
The Device list occupies the centre of the HiQnet Setup page, and will initially be completely empty. Once HiQnet has
been turned on, and a HiQnet network is attached to the console, the console will search for any attached AKG micro-
phones and display a list of the microphones found on the network in the left-hand column of the Device List.
Note: It may take up to 30 seconds to discover the mics.
The DEVICE column shows the names of all of the AKG microphones that have been discovered on the network. This
column is automatically populated.
The NET column in the list shows the HiQnet node address of the AKG Hub4000Q to which each microphone is con-
nected.
In the example shown above there is only one Hub4000Q connected, but it is possible for multiple Hub4000Qs to be
connected to the network, and in this case the number in the NET column will enable groups of mics attached to these
different Hubs to be distinguished from one another.
The SOURCE column in the list indicates the connector to which each microphone is associated. In order for the
VM² Device List
To Next Page
Loading...
Need help?
General