17.2.2 17.2.2: FX > ALGORITHMS > DELAYS
17.2.2: FX > ALGORITHMS > DELAYS
Tap Ratio Range Low Range High
Controls the Tap ratio
of left and right outputs
relative to the Delay
time.
Specic to the Pong Delay effect, this controls the delay
time offset between left and right taps, expressed as a
ratio of left to right time difference. In the centre the taps
have the same time (1:1).
1:12 12:1
Tap Swap Range Low Range High
Swaps the delay time
tap offset set by the Tap
Ratio.
Specic to the Pong Delay effect - reverses the offset set
by the Tap Ratio control.
L > R R > L
Delay Feedback
Controls the number
of delay repeats by
feeding the delay output
signal back into the
delay input.
This creates a series of delay repeats, each slightly
attenuated until they become inaudible. Higher settings
create more repeats; lower settings reduce the number
of repeats. When this knob is turned fully clockwise, it
engages Repeat Hold – delay repeats play back in an
innite loop, but no further input signal is introduced into
the delay effect. Repeat Hold is available only on Studio,
Mono and Pong Delay.
Low Cut Filter
Frequency Range Low Range High
Frequencies below this
level are attenuated.
Off > 20Hz 20kHz
High Cut Filter
Frequency
Frequencies above this
level are attenuated.
20Hz 20kHz<Off
Smear
Ducking attenuation
amount.
Available only for Tape and Reverse Delays, this param-
eter controls the amount of “smear,” or signal degrada-
tion and frequency loss. The higher the setting, the more
each delay repeat loses intelligibility compared to the
original signal.
0 99
To Next Page
Loading...
Need help?
General