Advanced-control timers (TIM1/TIM8/TIM20) RM0440
1178/2126 RM0440 Rev 4
Bit 13 OIS3N: Output idle state 3 (tim_oc3n output)
Refer to OIS1N bit
Bit 12 OIS3: Output idle state 3 (tim_oc3n output)
Refer to OIS1 bit
Bit 11 OIS2N: Output idle state 2 (tim_oc2n output)
Refer to OIS1N bit
Bit 10 OIS2: Output idle state 2 (tim_oc2 output)
Refer to OIS1 bit
Bit 9 OIS1N: Output idle state 1 (tim_oc1n output)
0: tim_oc1n=0 after a dead-time when MOE=0
1: tim_oc1n=1 after a dead-time when MOE=0
Note: This bit can not be modified as long as LOCK level 1, 2 or 3 has been programmed
(LOCK bits in TIMx_BDTR register).
Bit 8 OIS1: Output idle state 1 (tim_oc1 output)
0: tim_oc1=0 (after a dead-time) when MOE=0
1: tim_oc1=1 (after a dead-time) when MOE=0
Note: This bit can not be modified as long as LOCK level 1, 2 or 3 has been programmed
(LOCK bits in TIMx_BDTR register).
Bit 7 TI1S: tim_ti1 selection
0: The tim_ti1_in[15..0] multiplexer output is connected to tim_ti1 input
1: tim_ti1_in[15..0], tim_ti2_in[15..0] and tim_ti3_in[15..0] multiplexers outputs are XORed
and connected to the tim_ti1 input
To Next Page
Loading...
Need help?
General
