104 MS 441, MS 441 C
– Remove carburetor, b 14.3.
: Take out screw (arrow).
219RA224 TG
: Carefully remove end cover (1).
219RA225 TG
1
: Carefully remove gasket with
pump diaphragm from the end
cover.
219RA226 TG
: Carefully separate pump
diaphragm (1) and gasket (2).
The diaphragm material is
subjected to continuous alternating
stresses and eventually shows
signs of fatigue, i.e. the diaphragm
distorts and swells and has to be
219RA274 TG
1
2
replaced.
– Examine pump diaphragm for
signs of damage and wear,
replace gasket.
– Examine fuel strainer for
contamination and damage,
clean or replace if necessary.
: Pull fuel strainer (1) with needle
out of the carburetor housing and
clean it, replace if necessary.
– Reassemble in the reverse
sequence.
219RA227 TG
1
: Fit gasket (1) so that tab (2) is
opposite lug (3) and the gasket is
secured by the pegs (arrows).
219RA228 TG
12 3
: Place diaphragm (1) on the
gasket so that tab (2) is opposite
lug (3) and the diaphragm is
secured by the pegs (arrows).
219RA229 TG
1
2
3
: Fit end cover so that the lug
(arrow) points towards the
adjusting screws.
219RA230 TG
1
14.4.5 Pump diaphragm