Stihl MS 441

114 MS 441, MS 441 C
: Fit throttle cable (1) between
impulse hose (2) and fuel hose
(3), then hook it into carburetor
support (arrow).
219RA217 TG
2
1
3
Machines with handle heating
If the throttle cable retainer is
replaced, ensure that the wiring is
routed correctly (arrows).
– Reassemble all other parts in the
reverse sequence.
219RA504 TG
– Tightening torques, b 3.5.
– Remove carburetor, b 14.3.
– Remove switch shaft, b 12.1.
: Take out sleeves (1) and remove
washer (2).
219RA282 TG
1
2
1
: Pull out throttle cable (1), impulse
hose (2) and fuel hose (3).
219RA509 TG
2
1
3
: Press rubber lips (arrows) of
intake elbow out through the
openings in the carburetor
support (1) towards the cylinder.
219RA510 TG
1
– Remove carburetor support.
: Disconnect ground wire (1) from
contact spring (arrow).
219RA399 TG
1
: Remove air guide inlet (1) and
air guide outlet (2).
219RA511 TG
2
1
: Pull off preheating plate (1).
– Remove contact spring b 9.6.2.
219RA512 TG
1
14.6.1 Carburetor support