72 MS 441, MS 441 C
If the action of the starter rope
becomes very stiff and the rope
rewinds very slowly or not
completely, it can be assumed that
the starter mechanism is in order
but plugged with dirt. At very low
outside temperatures, the
lubricating oil on the rewind spring
may thicken and cause the spring
windings to stick together. This has
a detrimental effect on the function
of the starter mechanism.
To clean the rewind spring, it is
sufficient to apply a few drops of
commercially available solvent-
based degreasant not containing
any chlorinated or halogenated
hydrocarbons to the spring.
Carefully pull out the starter rope
several times and let it rewind until
its normal smooth action is restored.
Before installing, lubricate the
rewind spring and post with STIHL
special lubricant.
If clogged with dirt or pitch, the
entire starter mechanism, including
the rewind spring, must be removed
and disassembled. Take particular
care when removing the spring.
– Clean all components.
: Take out screws (arrows).
– Lift hand guard (1) slightly and
remove fan housing (2).
219RA366 TG
1
2
: Prise out segment (1) at the lugs
(arrows) and remove the fan
housing.
– Examine fan housing and
segment, replace if necessary.
219RA404 TG
1
: First slide segment (1) into the
slits (arrows) in the fan housing,
then press it home on the lugs.
219RA405 TG
1
– Reassemble all other parts in the
reverse sequence.
– Fit screws (arrows). The hand
guard is additionally secured with
the longer screw (1).
– Tighten screws.
– Tightening torques, b 3.5.
219RA406 TG
1
10. Rewind starter
10.1 General
10.2 Removal and installation
To Next Page
Loading...
Need help?
General
