35MS 441, MS 441 C
: Carefully drive the pins in with
gentle taps until the following
values have been reached:
Pin (1) a approx. 4.3...4.7 mm
Pin (2) b approx. 3.0...3.4 mm
Pin (5) c approx. 3.0...3.4 mm
a
c
b
Pin (6) is only found in the machines
with QuickStop Super.
The pins must be driven in square.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5.
– Grease brake and cam levers,
b 17.
– Remove chain sprocket cover,
bar and chain, b 5.
– Troubleshooting chart, b 4.2.
: Take out screw (arrow).
– Remove side plate (1).
19RA042 TG
1
: Turn spur gear (2) clockwise until
the tensioner slide (1) rests
against the right-hand side and
the screw (arrow) is visible.
219RA175 TG
1
2
: Take out screw (arrow).
219RA176 TG
: Pull out complete spur gear (1)
with a suitable tool.
219RA177 TG
1
: Pull out tensioner slide (1) with
a suitable tool.
219RA178 TG
1
7.6 Chain tensioner
To Next Page
Loading...
