Stihl MS 441

79MS 441, MS 441 C
– Remove shroud, b 8.4.
: Take out screws (arrows).
– Remove and examine anti-
vibration spring (1), replace if
necessary.
219RA304 TG
1
– Reassemble in the reverse
sequence.
– Tightening torques, b 3.5.
– Remove fan filter,
b 14.1.
– Remove spacer flange,
b 14.2.
For reasons of simplicity, the
carburetor housing is not shown in
the following illustrations.
– Remove anti-vibration spring on
front handle, b 11.2.
: Take out screws (arrows).
219RA305 TG
: Prise off anti-vibration spring (1).
219RA306 TG
1
– Examine anti-vibration spring,
replace if necessary.
: Ensure that spring (1) is fully
screwed into the bearing plugs
(arrows).
1
219RA307 TG
: Install anti-vibration spring so that
it engages the mounts (arrows).
– Fit screws.
– Ensure that bearing points are
correctly seated during
installation.
219RA308 TG
– Tighten screws.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5.
11.2 Anti-vibration spring,
front handle
11.3 Anti-vibration spring,
fuel tank