58 MS 441, MS 441 C
The ignition module accommodates
all the components required to
control the ignition timing. Only two
electrical connections emerge from
the ignition module.
– High-voltage output (1) with
permanently connected ignition
219RA365 TG
2
1
lead.
– Connector tag (2) for short circuit
wire.
Testing of the ignition module only
encompasses a spark test. The
ignition module must be replaced if
an ignition spark is not obtained
(although wiring and stop switch are
intact).
The ignition timing is fixed and
cannot be adjusted.
Since there is no mechanical wear
in these systems, the ignition timing
cannot become maladjusted during
operation.
– Remove fan housing,
b 10.2.
– Remove pre-separator, b 9.7.
– Release clamps (arrows).
: Remove carburetor box
cover (1).
219RA367 TG
1
: Pull boot off spark plug (1).
1
19RA015 TG
: Remove ignition lead (1) from
rubber buffer (2) and cable guide
(arrow).
219RA369 TG
1
2
: Disconnect short circuit wire (1).
: Take out screws (arrows).
219RA370 TG
1
: Remove ignition module (1).
219RA371 TG
1
9.1 Ignition module 9.1.1 Removal and installation
To Next Page
Loading...
