Stihl MS 441 User Manual

113MS 441, MS 441 C
Correcting the carburetor setting
for operation at high altitude
A minor correction may be
necessary if engine performance is
not satisfactory.
– Check standard setting.
– Let engine warm up.
– Turn high speed screw H
clockwise (leaner), but no further
than the stop.
If the setting is made too lean, the
engine may be damaged due to
insufficient lubrication and
overheating.
If these adjustments do not yield
any improvement, refer also to the
troubleshooting chart for ignition
system, carburetor and engine,
b 4.5, b 4.6 and b 4.7.
– Remove carburetor, b 14.3.
– Remove anti-vibration spring on
fuel tank, b 11.3.
: Disconnect throttle cable (1) from
lever (2).
219RA501 TG
2
1
: Pull throttle cable (1) out of guide
(arrow).
219RA502 TG
1
: Pull throttle cable (1) out of
carburetor housing.
– Examine throttle cable and
replace if necessary.
219RA115 TG
1
: Slide throttle cable (1) through
grommet (2) with the double-
nipple (arrow) first.
219RA133 TG
1
2
– Examine throttle cable retainer,
replace if necessary, b 7.3.2.
: Connect throttle cable (1) to
lever (2) and guide wire through
slot (arrow).
1
2
219RA378 TG
: Push throttle cable grommet (1)
into guide (arrow) of throttle cable
retainer (2).
219RA503 TG
2
1
14.6 Throttle cable

Stihl MS 441 Specifications

General

Displacement	70.7 cc
Weight	6.6 kg
Fuel Capacity	0.78 L
Chain Oil Capacity	0.36 l
Oil Capacity	0.36 l
Oil tank volume	0.36 l
Chain pitch	3/8"