94 MS 441, MS 441 C
The relevant settings are described
in the instruction manual.
In the case of oil pumps with
increased delivery rate, note that
the oil tank is empty before the fuel
tank and the saw chain may
therefore run dry when range "a" is
219RA471 TG
a
reached.
For setting range "a", the fuel tank
should therefore only be half-filled
or the oil tank refilled when the fuel
tank is half-empty.
The oil pump with increased
delivery rate can be identified via
the groove (1) or all-round groove
(arrow) in the pump piston.
219RA472 TG
1
A valve is installed in the tank wall to
keep internal tank pressure equal to
atmospheric pressure. The valve
must be replaced if faulty.
– Remove chain sprocket cover,
bar and chain, b 5.
– Unscrew oil tank cap and drain
oil tank.
Collect chain oil in a clean container
and dispose of it in accordance with
environmental regulations.
: Carefully drive valve out of the
housing from the outside, into the
tank, with a drift dia. 6 mm.
219RA475 TG
: Remove old valve (1) from oil
tank.
219RA476 TG
1
Ensure that valve is correctly
positioned.
: Insert valve in hole (arrow) of
engine housing.
219RA477 TG
: Carefully drive valve into hole in
engine housing from the outside
with a drift dia. 6 mm, noting the
insertion depth.
219RA478 TG
: Drive new valve into hole
a = approx. 2 – 3 mm.
– Reassemble all other parts in the
reverse sequence.
219RA479 TG
13.3.2 Adjustment 13.4 Valve
To Next Page
Loading...
