Stihl MS 441 - 14.6.2 Carburetor housing

115MS 441, MS 441 C
: Remove washers (arrows) and
pull out felt (1).
– Examine carburetor support and
all attached parts, replace if
necessary.
219RA513 TG
1
– Slide washers onto stud bolts.
: Slide preheating plate (1) onto
stud bolts so that it engages the
air duct (arrow).
219RA507 TG
1
: Fit air guide inlet (1) until it
engages the heel (arrow).
219RA508 TG
1
: Fit air guide outlet (1) until it
engages the heel (arrow). Peg (2)
must engage the notch.
219RA614 TG
1
2
– Install contact spring b 9.6.2.
: Slide felt (1) into mount.
– Examine impulse hose, replace
if necessary, b 14.6.4.
– Examine fuel hose, replace if
219RA515 TG
1
necessary, b 14.8.2.
– Examine throttle cable, replace
if necessary, b 14.6.
– Examine intake elbow, replace
if necessary, b 14.6.3.
: Tie a piece of string round each
flange (arrows), forming a loop
with a simple knot and gently
pulling it tight.
219RA516 TG
: Guide the ends of the string
through the openings (arrows) in
the carburetor support (1).
– Fit carburetor support against
intake elbow and slip ground wire
connector onto contact spring.
219RA517 TG
1