Stihl MS 441 - 14.5 Carburetor adjustment; 14.5.1 Basic setting

110 MS 441, MS 441 C
: Turn limiter cap until lug (2) is
lined up with groove (1).
The dot on the limiter cap must be
lined up with the mark (arrow).
219RA261 TG
2
1
L
H
: Pull off limiter cap (1).
– Unscrew low speed screw L.
1
219RA262 TG
: Examine tip (arrow) for signs of
damage or wear, replace low
speed screw L if necessary.
219RA263 TG
– Turn in low speed screw L until it
is fully in its seat.
– Continue with high speed screw.
High speed screw
: Screw puller (1) 5910 890 4500
onto limiter cap – left-hand
thread.
1
219RA265 TG
: Turn limiter cap until lug (2) is
lined up with groove (1).
The dot on the limiter cap must be
lined up with the mark (arrow).
219RA266 TG
2
1
L
H
: Pull off limiter cap (1).
– Unscrew high speed screw H.
1
219RA267 TG
: Examine tip (arrow) for signs of
damage or wear, replace high
speed screw H if necessary.
– Turn in high speed screw H until
it is fully in its seat.
– Continue with Fitting the limiter
219RA268 TG
caps.