Stihl MS 441

53MS 441, MS 441 C
Crankcase half on ignition side
: Carefully drive out oil seal with
a suitable punch.
219RA134 TG
: Examine and clean crankcase
half, replace if necessary.
Replace the ball bearing if the
crankcase half is OK.
219RA135 TG
– Heat area around bearing seat to
approx. 150 °C (300 °F).
The bearing (1) drops out of its own
accord when the required
temperature is reached.
219RA136 TG
1
– Heat area around bearing seat to
approx. 150 °C (300 °F).
– Position ball bearing so that the
open side (balls visible) faces the
outside of the crankcase.
: Press ball bearing fully home.
219RA137 TG
The ball bearing must be fitted
quickly as it absorbs heat and
expands.
Crankcase half on clutch side
: Carefully drive out oil seal with
a suitable punch.
219RA140 TG
: Examine and clean crankcase
half, replace if necessary.
Replace the ball bearing if the
crankcase half is OK.
219RA141 TG
– Heat area around bearing seat to
approx. 150 °C (300 °F).
The bearing (1) drops out of its own
accord when the required
temperature is reached.
1
219RA142 TG