Stihl MS 441 - Page 66

65MS 441, MS 441 C
: Pull short circuit wire (1) out of
the grommet (arrow).
The wiring harness (2) is
additionally drawn through the
grommet in machines with handle
heating, b 15.8.
N
2
219RA390 TG
1
: Pull short circuit wire (1) out
through the recess (arrow).
– Pull short circuit wire out of the
guides below the carburetor
support.
219RA391 TG
1
– Take short circuit wire out of the
guides (arrows).
219RA392 TG
: Carefully push retaining lug
(arrow) aside and pull out contact
spring (1).
219RA393 TG
1
: Examine short circuit wire (1),
contact spring (2) and
grommet (3), replace if
necessary.
The wiring harness must
additionally be pulled off the
generator lead in order to replace
219RA394 TG
1
3 2
the grommet in machines with
handle heating, b 15.8.
: Push contact spring (1) fully
home in the guide.
Ensure that the contact spring is
secured by the retaining lug (arrow).
219RA395 TG
1
: Slide the short circuit wire
through the opening (2) and
grommet (1), then connect it to
the ignition module (arrow).
219RA396 TG
1
2
– Fit the short circuit wire in the
guides, starting at the ignition
module.
: Press short circuit wire (1) in
guides (arrows).
219RA397 TG
1
2