82 MS 441, MS 441 C
: Lift front handle (1) slightly at the
side and remove it from the guide
(arrow).
1
219RA320 TG
: Slide front handle (1) out of lower
guide and turn it towards the
spiked bumper.
– Remove front handle.
219RA321 TG
1
: First lift stop (1) out of bottom
mount (arrow) and then pull it up
and off.
1
219RA322 TG
: Pull handle inlays (1) out of front
handle (2).
– Examine handle inlays, front
handle and stop, replace if
necessary.
– Slide handle inlays (1) back into
2
1
1
219RA323 TG
front handle.
: First push stop (1) into the upper
ridge (arrow), then press it into
the lower mount.
219RA324 TG
1
: First position front handle (1)
against the bottom handle mount
(arrow), then turn it towards the
rear handle.
219RA326 TG
1
: Lift front handle (1) slightly at the
side and ease it into the guide
(arrow).
– Ensure that the stop is correctly
positioned.
– Fit and tighten screws.
1
219RA327 TG
– Reassemble all other parts in the
reverse sequence.
Tightening torques, b 3.5.
To Next Page
Loading...
