86 MS 441, MS 441 C
: Pull out the lever (1).
: Unhook leg spring (2) from
throttle trigger.
219RA348 TG
1
2
– Examine throttle trigger (1),
lever (2), trigger interlock (3) and
leg spring (4), replace if
necessary.
4
219RA349 TG
23
1
: Hook leg spring (1) into throttle
trigger (2), noting the installed
position (arrow).
219RA350 TG
2
1
: Push lever (1) into place.
– Turn throttle trigger with lever
over.
219RA351 TG
1
: Push throttle cable (1) into hole
until the wire engages the guide
(arrow) of the lever (2).
219RA352 TG
12
Machines with handle heating
Ensure that the wiring is located in
the guides (arrows).
219RA353 TG
: Centre the throttle trigger (1) with
punch (2).
– Drive in the pin until it is
equidistant on both sides.
2
219RA354 TG
1
: Centre lever (1) with punch (2).
– Drive in the pin until it is
equidistant on both sides.
2
219RA355 TG
1
: When installing the trigger
interlock, ensure that the stop (1)
engages the guide (arrow).
219RA356 TG
1
To Next Page
Loading...
