Strasbaugh Mechanical Maintenance Procedures
Version 1.2 - April 18, 1996 7 - 9
This can be done by carefully pushing the pick and place 2
chuck down on the work chuck and releasing.
An alternative to the manual dressing operation above is to
grind the disk as a wafer using the auto cycle. This requires a
disk mounted on a pad that is compatible with the wafer
transport system. A single grind may be programmed with the
appropriate parameters for the disk dimensions. This provides a
more convenient dressing operation.
After wheel dressing or truing it is necessary to reinitialize
the machine due to wheel wear.
To Next Page
Loading...