Strasbaugh 7AA - Edit;Create Dual Grind Parameters F4; Directory of Grind Parameters F5; Directory of Wafer Data Files F6

Strasbaugh Software Calibration Procedures
Version 1.2 - April 18, 1996 8 - 7
EDIT/CREATE DUAL GRIND
PARAMETERS 'F4'
To edit old or create new dual grind parameters press 'F4' from
the main menu.
To create new parameters or edit old ones press the letter of
the associated parameter and enter the desired parameter
followed by the 'enter' or 'return' key.
To load existing grind parameters press 'L' and enter the name
of the file with the dual grind parameters to be edited.
To save grind parameters press 'S' and enter the name of the
file with the dual grind parameters to be saved, the file will be
saved on the disk. (Back-up copies are made if the file exists)
To return to the main menu press 'Q' .
DIRECTORY OF GRIND
PARAMETERS 'F5'
To display a directory of all grind parameter files on the disk
press 'F5' from the main menu. There are a number of pauses
for you to examine the file names.
DIRECTORY OF WAFER DATA FILES
'F6'
To display a directory of all wafer data files on the disk press
'F6' from the main menu. There are a number of pauses for you
to examine the filenames.