Strasbaugh 7AA - Lockout Safety Procedure

Strasbaugh Introduction
Version 1.2 - April 18, 1996; Update 11/6/96 1 - 17 U
LOCKOUT SAFETY PROCEDURE
(Reproduce for shop copy. Fill-in data or check off as appropriate.)
EQUIPMENT LOCATION:
MODEL 7AA SERIAL NUMBER:
MANUFACTURER:
Strasbaugh, Inc.
PROCEDURE AUTHORIZED BY:
DATE:
PHONE:
DEPARTMENT:
OSHA regulations state that "The procedures shall clearly and specifically outline the scope,
purpose, authorization, rules and techniques to be utilized for the control of hazardous
energy, and the means to enforce compliance including, but not limited to the following:
A. A specific statement of the intended use of the procedure.
B. Specific procedural steps for shutting down, isolating, blocking and securing machines
or equipment to control hazardous energy.
C. Specific procedural steps for the placement, removal and transfer of lockout devices or
tagout devices and the responsibility for them; and
D. Specific requirements for testing a machine or equipment to determine and verify the
effectiveness of lockout devices, tagout devices, and other energy control measures."
SOURCES OF ENERGY FOR THIS EQUIPMENT: *
Electrical 120 V.A.C. ___ Gas ___ Hydraulic ___
Electrical 208 V.A.C. _√_ Chemical ___ Pneumatic ___
Compressed Air _√_ Thermal ___ Other (specify) ___
STORED ENERGY (Remember energy can be stored!): *
Raised Load _√_ Air Tank ___ Coiled Springs _√_
Chemical ___ Charged Capacitors _√_ Hydraulic Pressure ___
Battery ___ Pneumatic Pressure _√_ Other (specify) ___
* Note: Some checks provided ... others may apply.
MACHINE MAINTENANCE MANUALS:
Refer to the machine maintenance manual(s) before attempting any activities for which this
procedure applies. The maintenance manual(s) are usually the best single source of
information vital to the understanding of the machine and hazards which may be present.