Operation and Maintenance Manual Model 7AA Wafer Grinder
8 - 6 Version 1.2 - April 18, 1996
TRANSFER GRIND PARAMETERS
FROM DISK TO MACHINE 'F2'
To transfer grind parameters stored in disk file to the Model
7AA memory, insure that the 7AA is at the main menu and
press 'F2' on the PC.
Respond 'S' or 'D' to the parameter type to be transferred. You
will then be asked for the filename to be used as the source of
parameters. If the file exists respond to the prompt to continue
or abort by pressing 'C' or 'A'.
If the 7AA is not in the proper menu an error message will be
displayed and you will be given an opportunity to restart the
transfer.
EDIT/CREATE SINGLE GRIND
PARAMETERS 'F3'
To edit old or create new single grind parameters press 'F3'
from the main menu.
To create new parameters or edit old ones press the letter of
the associated parameter and enter the desired parameter
followed by the 'enter' or 'return' key.
To load existing grind parameters press 'L' and enter the name
of the file with the single grind parameters to be edited.
To save grind parameters press 'S' and enter the name of the
file with the single grind parameters to be saved, the file will be
saved on the disk. (Back-up copies are made if the file exists)
To return to the main menu press 'Q' .
To Next Page
Loading...