Operation and Maintenance Manual Model 7AA Wafer Grinder
4 - 24 Version 1.2 - April 18, 1996
STEP 6 - START MACHINE AUTO
CYCLE
After all parameters have been correctly entered, the machine
is ready to run in the auto cycle mode. Select the desired grind
mode. Send and receive cassettes should be in place.
To initiate the auto cycle press the "START" key. To halt the
auto cycle press the "STOP" key and the cycle will pause at the
next convenient step in the cycle. To restart the cycle press
"START".
The cycle will continue until an error condition arises or the
cycle is aborted. If "Cycle Abort" is displayed, the machine
must be reset to start the cycle again. Push "RESET" to display
the machine operation menu and proceed as above to restart
the auto cycle.
Pushing "RESET" during an auto cycle will immediately disable
all machine motion.
To Next Page
Loading...