Strasbaugh Pneumatic Adjustments
Version 1.2 - April 18, 1996 9 - 3
PNEUMATIC
ADJUSTMENTS
Notes
When performing pneumatic adjustments, in addition to the information
listed below in this chapter, refer also to the following:
• the Strasbaugh 7AA Maintenance Videos (a three-volume set).
• the Giddings and Lewis PiC409 Family User’s Manual.
• the Mechanical Adjustments chapter (Chapter 7) of this manual for
information on manual control of the machine.
• the Software Calibrations chapter (Chapter 8) of this manual for
information on machine diagnostics.
Assumption
The procedures below were written with the assumption that the reader
is thoroughly familiar with the 7AA Wafer Grinder. If not, read the
chapters in this manual on Machine Description, Installation, Operator
Functions, and Machine Setup before beginning any procedure.
To Next Page
Loading...